PMDF System Manager's Guide


Previous Contents Index

26.3.1 Defragmentation Channel Definition and Rewrite Rules

If your configuration was generated by the PMDF configuration utility 2 (PMDF V4.1 or later), then you do not need to add a defragmentation channel to your configuration: this was done automatically for you by the configuration utility. See the appropriate edition of the PMDF Installation Guide for instructions on using the configuration utility.

The first step in installing a defragmentation channel is to insert the channel entry in PMDF's configuration file. The entry should have the form:


defragment 
DEFRAGMENT-DAEMON 

Rewrite rules can be added if desired to make it possible to queue mail explicitly to the defragmentation channel. To do this, add the rewrite rules


defragment                $U@defragment.localhostname@DEFRAGMENT-DAEMON 
defragment.localhostname  $U@defragment.localhostname@DEFRAGMENT-DAEMON 
where localhostname should be replaced by the name of the local host. Once this is done, an address of the form


user%host@defragment.localhostname
will be routed through the defragmentation channel. (Sending anything other than a message/partial message to the defragmentation channel causes the channel to simply requeue the message for normal delivery.)

Note

2 The web based configuration utility, or the command line utility pmdf configure (UNIX) or PMDF CONFIGURE (OpenVMS) or in older versions of PMDF for OpenVMS, one of the command procedures configure.com or access_configure.com


Previous Next Contents Index